"Complaint of unit freezing up again. Confirmed complaint, cleared all ice from freezer evap, found harness for defrost heater is not staying in place, would need to replace harness, quoted part: W11650660 $104.81, labor $123.00. Spoke with partner team to see about any coverage of unit, partner team advised customer has extended warranty through AIG, waited on hold while defrosting fridge for over and hour, unable to hold any longer, recommended to call AIG first thing in the morning to get a dispatch from them before ordering part. AIG phone number: 866-265-2137"

"Found freezer evaporator frozen over, cleared evaporator, checked defrost thermistor, checked heating element, found wire harness to heating element was not installed correctly causing half power to element and poor defrosting, reinstalled wire harness and secured, tested unit, heating element is getting correct voltage and heating up, informed customer to give 24 hours for unit to get to normal temps, checks OK."

DISHWASHER WHIRLPOOL WDT750SAHZ0 "Checked incoming power, power is at 124 VAC, replaced control board, tested unit, unit started drain normally, then stopped, did not start again, called techline, after testing multiple things, techline advised to replace harness and control board. Techline file number: 7727465630; ordrng 1 W10899401 (harns-wire) and 1 W11305297 (cntrl-elec)"

DISHWASHER WHIRLPOOL WDT750SAHZ0 Checked incoming power was at 244vac.. fuse on control board was blown...informed home owner of electrical issue..told home owner to have electrical issue repaired before we come back with part..; ordrng 1 W11305297 (cntrl-elec)

DISHWASHER WHIRLPOOL KUDC10IXBL0 "Complaint of unit not finishing cycle, not going through dry cycle. checked incoming power lines, unit is connected through light switch, when switch is off, unit is receiving 6.06 VAC, at all times, when switch is on unit is receiving 124.4 VAC. Checked error codes, 6-4, during diagnostic test cycle, owi sensor registered correctly, float sensor tested normal, all other functions came on normally. Found drain loop had fallen down from proper position under sink. Replaced full drain hose, ran diagnostic test cycle, all functions normal, no leaks, all checks ok."