Replaced door. Unit still won't start cycle or enter diagnostics. Called tech support. (Rory) was told to check DC circuits for possible drag not allowing unit to work. Including ntc thermistor pressure sensor and load and go sensors. When bottom drawer is open unit would allow password to be entered for diagnostics. Unit will not run full diagnostics cycle when it gets to motor spin part of test it locks up. Unplugged motor from acu all windings checked good per tech support. Changed pressure sensor and heater with ntc thermistor. Reassembled back cover and retested. Again unit would not allow password to be entered until bottom drawer was opened. Entered password and diagnostics cycle stopped in same spot. According to tech support issue could be with a DC sensor or in wiring. Ordering dispenser bracket assembly and wire harnesses. If dispenser assembly for load and go does not fix issue washer will have to be rewired to rule that out per tech support. Will need oven cart to remove dryernfrom top of washer. ; ordrng 1 W11321065 (Dispenser load and go assembly) and 1 W11509202 (Harness lower) and 1 W11437863 (Harness ntc) and 1 W11133142 (Upper harness.)

"Found unit never cooled down after repair, on arrival found amp draw of 0.4 and no frost pattern, pressures at 60 and -14 and equalized at 5 before high side started to rise again. Pressurized system to 135 PSI and leak checked evap, condenser, and compressor area, could not find leak. Per techline unit is being sent to product review, will contact customer with next steps."

"Replace compressor when piercing the filter dryer had no refrigerant leak out thought possibly and evaporator leak after cutting the compressor out pressure tested the system unable to verify any leaks in the system anywhere replace the compressor recharge for 47 G r600 Unit operating properly at this time; used 1 WPW10618107 (Fitting), and 5 R600 (R600) from stock"

Removed power disassembled dishwasher removed door. Separated door and replaced panel. Pulled out dishwasher attached springs and put door back on. Rewired and reassembled bottom of unit. Tested for proper operation. Panel was scratch during re-installing. Will have to re order control panel. ; ordrng 1 WD21X25369 (Console)

Pulled out stove removed power. Installed new control. Tested all buttons and oven operation checks ok.