"Checked for error codes, no stored error codes, tested unit, no noises, checked cam assembly, checked shifter, checked gear case, checked belt, found belt is slipping on cam, replaced belt, calibrated unit, ran test cycle, unit is functioning properly, no noises at this time, informed customer popping, and clicking noises are normal, checks ok.; used 1 W11239857 (Belt) from stock"

"Replaced dual valve, tested dispenser, still has low water flow, advised to have plumber check on incoming water line for correct pressure. A cold water supply with water pressure of between 35 and 120 psi (241 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber. NOTE: If the water pressure is less than what is required, the flow of water from the water dispenser could decrease or ice cubes could be hollow or irregular shape"

"Found ice dispenser bend, was frozen over in gears causing unit to not dispense ice, cleared out ice and dispenser gears, and informed customer to leave out to air dry for a few hours before putting back in, tested auger motor, auger motor is spinning normally, tested ice bin, ice bin is spinning Normally, customer to observe, checks OK."

"Replaced igniter on unit, tested unit, unit is heating normally, checks okay at this time."

"Replaced tub, tested unit, unit is now making no noises, customer is to observe all checks okay at this time."