Appliance Repair Wilberforce Ohio

A to Z Appliance Service Rated out of 5 stars based on customer reviews

We serviced a
MAYTAG DRYER
Model MED4500MW0
Near Wilberforce, OH 45384
Joel L.
Job Details: 01/24/2024
Instructed customer on Center Drive cycles and load sizing for optimum drying performance. Confirmed proper cycling the heating element and airflow and venting out of unit. All sounds are normal. Used to tie to secure a court for safe and proper operation. All other checks are good. Customer to observe; used 1 W11390781 (Tie) from stock
We serviced a
FRIGIDAIRE REFRIGERATOR
Model FFHS2611LBK
Near Wilberforce, OH 45384
Terry
Job Details: 01/22/2024
Customers complaint is that it's freezing things in the refrigerator section upon investigation and test 5 to operate the damper assembly the damper motor is running but it is not closing the damper which is allowing full air from the freezer section to migrate to the refrigerator unit is going to need the damper assembly replaced 242303001 damper. $181.41. Labor $72.45 total
We serviced a
FRIGIDAIRE REFRIGERATOR
Model FFHS2611LBK
Near Wilberforce, OH 45384
Daniel
Job Details: 01/11/2024
"Replaced temperature sensor assembly, verify that danfor motor is opening and closing normally at this time, customer to observe, all checks okay"
We serviced a
FRIGIDAIRE REFRIGERATOR
Model FFHS2611LBK
Near Wilberforce, OH 45384
Daniel
Job Details: 01/09/2024
"2316904683Found that freezer and refrigerator temperature sensors are far out of range, ordering temperature sensors; ordrng 1 242278801 (Sensor assembly)"
We serviced a
FRIGIDAIRE REFRIGERATOR
Model FFHS2611LBK
Near Wilberforce, OH 45384
Daniel
Job Details: 01/02/2024
"Inspected unit, customer stated that they had a large amount of frost and Ice built up around the top side of the door and on the evaporator, found that evaporator drain was frozen over, verified that drain is clear at this time, customer had let unit defrost and everything has been running good for about a week, reassembled the evaporator panel and advise customer to observe unit temperatures for 2 or 3 days, all checks okay at this time"